x86/S3: put data segment registers into known state upon resume

x86/S3: put data segment registers into known state upon resume

wakeup_32 sets %ds and %es to BOOT_DS, while leaving %fs at what
wakeup_start did set it to, and %gs at whatever BIOS did load into it.
All of this may end up confusing the first load_segments() to run on
the BSP after resume, in particular allowing a non-nul selector value
to be left in %fs.

Alongside %ss, also put all other data segment registers into the same
state that the boot and CPU bringup paths put them in.

Reported-by: M. Vefa Bicakci <m.v.b@runbox.com>
Signed-off-by: Jan Beulich <jbeulich@suse.com>
Reviewed-by: Roger Pau Monné <roger.pau@citrix.com>
Reviewed-by: Andrew Cooper <andrew.cooper3@citrix.com>